How does it work?

In order to use its functions – you have to connect it to the SD card port of your phone. The SD port may be located on the left, right or rear (battery) part of your phone. If your phone has no SD port – you must use Y-cable.



Operation mode!

There are 2 operation mode for XTC 2 Clip device:
DIRECT – when the phone is in fastboot mode & connected to the PC, using the XTC 2 Clip software
OFFLINE – when using a SIM Lock menu of bootloader. To use the offline mode you must first save special service files on XTC 2 Clip device.
DIRECT MODE
To use direct mode:
  • Insert XTC 2 Clip device into phone SD card slot, power on phone into bootloader mode using “vol-down + pwr” button. And select “FASTBOOT” option.
  • Connect phone to your PC.
  • Run the XTC 2 Clip software and select “Direct mode”.
  • Choose the desired operation and press corresponding button.
OFFLINE MODE
  • Connect the XTC 2 Clip device to your PC using any compatible microsd card reader.
  • The device will be detected as a flash/disk drive.
  • Run the XTC 2 Clip software and select “SD editor” tab.
  • If you have previously had your service files on your device, please press “Read from drive” button, otherwise you will lose all your existing files once used the “Save to drive”.
  • Select the options you need and press “Save to drive”
  • Insert XTC 2 Clip device into phone SD card slot, power on phone into bootloader mode using “vol-down + pwr” button and select “SIMLOCK” option.

SUBSCRIBE TO OUR NEWSLETTER

Scroll to top